+38 (044) 499-60-60info@aton.ua

Steel Tank accumulator ATON Hot Safe

Aton Hot Safe - steel Tank accumulator

The design of the tank, a thermal energy storage accumulator, is based on the layers distribution of the heat carrier over its entire volume, with a clear separation of zones with high and relatively low temperatures.

Due to the tank design it is possible to adjust the temperature of the coolant during operation. This allows a qualitative and quantitative influence on the duration of the heating system operation without using a heat source up to 16 hours.

The tank is designed to work both in open and closed heating systems with overpressure not exceeding 4 atm.

The convenient ergonomic arrangement of the connection points for the tank allows it to be located in the corner of the installation room.

Aton Hot Save design ensures convenient installation and easy service.

 

Parameters Unit Model
    400 500 700 1000
Purpose of equipment   Accumulation of thermal energy
Tank capacity l 400 500 700 1000
Heating pipe connections inch 1 1/2 1 1/2 1 1/2 1 1/2
Exhaust pipe inch 1/2 1/2 1/2 1/2
Temperature sensor connection inch 1/2 1/2 1/2 1/2
Plumbing outlet coolant inch 1/2 1/2 1/2 1/2
Heating water temperature, max. °С 90 90 90 90
Maximum pressure bar 4 4 4 4
Thermal insulation thickness mm 100 100 100 100
Dimensions:    
Diameter (without insulation) mm 600 600 750 860
Diameter (with insulation) mm 800 800 900 1000
Height mm 1700 2100 2100 2200
  • Mineral wool thermal insulation;
  • Insulation layer - 100 mm;
  • Bottom part designed with correct geometry for even distribution of load;
  • Minimum number of welds, total - 3;
  • Bumpers for distribution of internal water flows.