+38 (044) 499-60-60info@aton.ua

Gas convectors ATON Vektor – efficient and affordable heating

...Modern convector ATON Vector - is a highly effective and economical device for autonomous heating. The principle is simple - in a sealed chamber gas. is burning Thanks to the steel enameled heat exchanger heats quickly and without heat loss. the air in the room Air intake and release of products of combustion produced by a special coaxial (tube in tube), air intake, all of the street....

Gas convectors differentiate by the following features:

· For categories (characteristics of gases and pressures for which they are intended):

  • on the main gas (methane) with a working pressure range 13-20 mbar
  • on the balloon liquefied gas (propane, propane-butane) with a working pressure range 30-45 mbar

· By type (in accordance with the methods of venting and air supply for combustion):

  • chimney (the flow of air into the combustion chamber and flue gas removal occurs due to natural draft, with the air necessary for combustion comes from the premise of the set device)
  • parapet (installation of a coaxial air intake system and smoke exhaust through the wall of the room on the level of heating device installation)

· According to the principle of action (natural or forced convection):

  • heating of the indoor air by natural convection
  • heating the air indoors by forced convection (with fan)

· In the heat exchanger material:

  • cast iron
  • steel

Nowadays the most widely used parapet steel convectors with natural convection, designed to run on methane, with the possibility of reconfiguring of liquefied gas. In Ukraine, the installation of convectors regulates DBN B.2.5-20-2001 GAS SUPPLY.

Modern convector ATON Vector - is a highly effective and economical device for autonomous heating. The principle is simple - in a sealed chamber is combustion of gas. Thanks to the steel enameled heat exchanger heats the air in the room quickly and without heat loss. Air intake and release of products of combustion produced by a special coaxial (tube in tube), air intake, launched into street. Reliable automatic of Italian company SIT provides a high level of safety and convenience of using the device. What's important, the convector ATON Vector - is heating system of a complete cycle, it does not require any additional components. Production of convectors takes place with the same modern technological equipment that floor gas-fired boilers ATON Atmo does.

We consider in detail the principle of the convector. Structurally, the convection heater consists of a:

  • Gas-burning devices, which in turn consists of a gas valve 630 SIT (Italy) and the burner POLIDORO (Italy)
  • Enameled steel double chamber heat exchanger (with a larger surface area and consequently greater heat output)
  • Decorative steel body, acting as a heater convective type (provides air circulation)
  • The set for intake air duct and flue outlet

Gas convectors ATON Vektor – efficient and affordable heatingGas convectors ATON Vektor – efficient and affordable heating

 

We now consider the principle of operation of the heater. With piezo ignition pilot burner lights, then the gas is fed to the main burner, the hot exhaust gases passing through the heat exchanger its walls is heated. From the heated walls of heat exchanger warms the room air passing through the holes in the decorative casing of the convector. After the heat exchanger warmed to a predetermined temperature (adjustment range 13 ° C - 38 º C installation room air), using a temperature sensor closes the gas valve. Pilot burner stays on. After cooling coil gas valve opens again (with a temperature sensor) and lights the main burner. Thus, the desired temperature is maintained automatically, with convector does not depend on external sources of energy. With the loss of gas in the line pilot burner goes out when the gas is blocked at the valve with the control electrode of the flame.

Gas convectors ATON Vektor – efficient and affordable heating

Thus, the convector ATON Vector is completely safe autonomous energy independent radiator. Long life is ensured by a heat exchanger layer of enamel that protects the heat exchanger from burning out.

The high consumer qualitiy convectors ATON Vector appreciated by consumers, not only in Ukraine but in Russia and Hungary, where much of the exported output.

The use of gas convectors due to the following consumer properties:

  • Low cost, convector (with a minimum capacity of the model range - 2.2 kW) ATON Vector 2.2 costs 1362 hrn, but the convector (with maximum power in the model range - 5 kW) ATON Vector 5 costs 1512 hrn
  • The absence of coolant (water that can freeze) and the heating system (pipes, radiators, fittings, etc.), as convector radiator is a direct effect, the heat from the combustion gas warms directly convector heat exchanger, and from the heat exchanger warms the air of the room
  • he maximum thermal power of in the model range up to 5 kW
  • The possibility of reconfiguration for work on propane-butane
  • Possibility maintain a minimum air temperature in an unhabited premises with the ability to quickly warm the room installation (within hour)

Thus, the scope of the convector usage:

· Premises a non-permanent residence, such as:

  • countryside houses, villas, hotels, recreation centers, etc. In the absence of economic activity in certain areas convectors can be switched off or to maintain the minimum required temperature in silent mode
  • auxiliary and technical facilities and outbuildings, baths, garages, workshops, greenhouses, etc.
  • small apartments in apartment buildings

· In case of reconfiguring convector for liquefied gas:

  • cottages and garden houses in areas not gasified
  • small shops, service businesses located near highways, etc.
  • shift cabins and trailers

It would seem that a gas convector is only advantages. The question arises - why have not they replaced the other heat generators?

The answer is simple - along with the advantages of a convector there are some disadvantages:

  • According to the rules of supply of gas convector is carried out on an outside wall, if the convector one / two (a small house), it looks fine, but big house entangled network of gas pipelines looks unaesthetic.
  • Price. You must install a convector for each window. If (in a small house), one / two convector (room and kitchen) clearly cost less traditional water heating system, in the house with the number of convectors more than four / five, traditional system of wins in the values.
  • Wind. When wind speeds above 15 m / s, convector is unstable (it blows). Beaufort scale of 15 m / s - that's 7 points out of possible 12, the wind is described as "strong" on the ground - trees swing
  • The maximum thickness of the wall - 600 mm, minimum - 200 mm, if the wall is more or less - unstable work of device.

Thus, gas parapet convectors confidently take its place - the budget heating of small objects.